The compression tool T5008 is for compressing waterproof connectors. It connects radial connectors to coaxial cable. And it customizes the length of cable used to connect components.
Instructions:
Step 1:
1) Trim back the outer jacket approximately 1/2”
2) Trim the braided wire to approximately 1/4” length and fold it back over the outer jacket
3) Remove approximately 1/4” from the dielectric. This should leave approximately 1/4” of center conductor exposed and 1/4” of the dielectric exposed. Please review the diagram as shown.
Step 2:
Insert the stripped cable into the connector. Push until dielectric rests against the bottom of the relating ring inside the connector.
Step 3:
Place the connector with cable into the tool’s holder.
Step 4:
Squeeze the handles.
Step 5:
Remove the compressed connector from the tool.
For example, it can be used for our F connector model No.CT5083/RG59.
Size: 215*52*20mm(L*W*H)
Net Weight: 450g(490g including blister packing)
